Draw and annotate four labelled diagrams illustrating the injection molding process.
- The polymer material is loaded into a hopper (in pellet form).2. The pellets go through an Archimedes screw surrounded by a heating element which melts the polymer.3. A ram forces the polymer into the die.4. The die is opened. The formed polymer is removed and flash is removed.
MV
Answered by Michael V. • Design & Technology tutor
2384 Views
See similar Design & Technology GCSE tutorsRelated Design & Technology GCSE answers
All answers ▸Diagram B (will be supplied) shows a light sensor potential divider. i) what is component A? ii) what is Vs?
Calculate the total resistance of a circuit with a 300 ohm resistor and 250 ohm resistor in parallel with one another.
What is meant by an iterative design process?
(Textiles) What are the 3 key fibre classifications? Give an example for each category.